The Davies Multipro 7 Pressure System with Hydrogenie 4.1 or 5 Controller and Pressure Tank is a high-performance water pressure boosting system designed for residential and commercial use. It is available with the option of a Hydrogenie 4.1 controller for single-phase applications or a Hydrogenie 5 Controller for three-phase applications.
The Hydrogenie Controller is an advanced water pressure management system that utilizes a unique algorithm to provide consistent water pressure while minimizing energy consumption.
The pressure tank is made of high-quality steel and designed to maintain a constant pressure in the system. It helps to prevent water hammer, reduces pump cycling, and extends the life of the system.
The Davies Multipro 7 Pressure System is capable of boosting water pressure up to 70 PSI and can handle flow rates of up to 25 GPM. It is easy to install and comes with all the necessary components for a hassle-free setup.
Overall, the Davies Multipro 7 Pressure System with Hydrogenie 4.1 or 5 Controller and Pressure Tank is a reliable and efficient solution for boosting water pressure in your home or business. The choice between the Hydrogenie 4.1 or 5 Controller allows you to select the appropriate system based on your power supply requirements.
Pump Features
● 304 Stainless steel impellers, Diffusers, seal plate & Pump casing
● 303 Stainless steel pump shaft
● Quiet & Low running cost
Typical Applications
● House and farm water supply
● Pressure boosting
● Water treatment
● Industrial circulation
● Hot water cleaning systems
Operation limitations
● Maximum ambient temperature: +40ºc
● Liquid temperature range: -15ºc to + 110ºc
● Maximum operating pressure: 8.5bar/125PSI
Supplied With
- Hydrogenie 4 (1Ph) or Hydrogenie 5 (3Ph) controller
- Galv Base mounting stand
- 24 Litre pressure tank and connection hose
- Check valve and Ball valve
- Assembled and test run
Controller Features
Hydrogenie 4.1
- Max pressure: 8Bar.
- Operating temperature range: -0 to +60ºC.
- Connection Thread: 1 1/4” male.
- Minimum pump pressure: 1.0Bar.
- Motor overload protection – adjustable.
- Start pressure adjustable from 0.5 – 7.0bar.
- Stop pressure (if in Pressure dependent mode) adjustable 1 to 8bar
- Automatic reset/restart following run dry: If the pump runs dry the controller will attempt to re-prime after 5 minutes. consecutive attempts are performed every 30 minutes.
Hydrogenie 5
- 230V Single phase or 400v Three phase
- Max 10A rated (per phase)
- Max 10bar rated
- Motor overload protection
- Over and under voltage protection
- Short between phases protection
- Run Dry protection
- Auto restart function
- Start pressure range 1-5bar (on/off mode)
- Max start pressure 6.5bar (pressure dependent mode)
- Max stop pressure 7 bar (pressure dependent mode)
- IP55 protection
- Adjustable start and stop delay
- Instantaneous digital screen displays: Line pressure, set pressure, Amp draw, Flow sensor position, controller temperature
