FEATURES & BENEFITS:
- IP55 (TEFC) motor – with IP55 protection from dust and water the PPP pumps are preserved against elements for many years.
- Stainless steel motor shaft.
- Electrical approvals – the PPP series pool pumps have passed all stringent Australian standards AS/ NZS3136:2001 for safety and is approved for installation within the wetted zone of the pool area, approvals V99108, V02301, V02302.
- Self-aligning barrel unions – Onga’s unique 5 degrees self-aligning barrel unions make pipe work connection a breeze.
- Plastic Yoke and Lip-Seal – The wet end design integrates a moulded end-shield cover and lip seal,protecting the motor from water damage.
- Mechanical Seal – A heavy-duty 3/4″ 316 Stainless Steel mechanical seal (on all models) provides extended life and longer intervals between servicing.
• Swimming pools from 20,000 litres up to 100,000 litres.
• Solar heating circuits.
• Above ground pools.
Suitable for pumping clean non-aggressive liquids without solids or fibers in suspension.
3 year limited warranty.
|Maximum working pressure||295 kPa|
|Water (Swimming Pool) temp range||5ºC-35ºC|
|Ambient temperature||50ºC maximum|
|Type||TEFC 2 pole continuously rotated|
|Nominal speed||2800 rpm|
|Insulation class||Class F|
|Thermal overload||Inbuilt auto reset|
|Temperature rise||Class B|
|Bearing type||Deep groove ball bearing with double contact lip seal|
|Bearing temperature rating||150ºC|
|Pump casing||20% glass filled with ABS|
|Clacker||20% glass filled with polycarbonate|
|Impeller||20% glass filled with ABS|
|Baffle||20% glass filled with ABS|
|Drain plug||20% glass filled with ABS|
|Diffuser||20% glass filled with ABS|
|Motor shaft||400 series stainless steel|
|End shield||Powder coated cast iron|
|Hair and lint pot O-ring||Low friction nitrile|
|Mechanical seal, 1/2″ type 6 (LTP1100 = type 6 3/4″|
|Spring||18-8 stainless steel|