FEATURES & BENEFITS:
- IP55 (TEFC) motor – with IP55 protection from dust and water the PPP pumps are preserved against elements for many years.
- Stainless steel motor shaft.
- Electrical approvals – the PPP series pool pumps have passed all stringent Australian standards AS/ NZS3136:2001 for safety and is approved for installation within the wetted zone of the pool area, approvals V99108, V02301, V02302.
- Self-aligning barrel unions – Onga’s unique 5 degrees self-aligning barrel unions make pipe work connection a breeze.
- Plastic Yoke and Lip-Seal – The wet end design integrates a moulded end-shield cover and lip seal,protecting the motor from water damage.
- Mechanical Seal – A heavy-duty 3/4″ 316 Stainless Steel mechanical seal (on all models) provides extended life and longer intervals between servicing.
APPLICATIONS:
• Swimming pools from 20,000 litres up to 100,000 litres.
• Solar heating circuits.
• Above ground pools.
OPERATING CONDITIONS:
Suitable for pumping clean non-aggressive liquids without solids or fibers in suspension.
3 year limited warranty.
| Fluid | Water |
| Maximum working pressure | 295 kPa |
| Water (Swimming Pool) temp range | 5ºC-35ºC |
| Ambient temperature | 50ºC maximum |
MOTOR
| Type | TEFC 2 pole continuously rotated |
| Nominal speed | 2800 rpm |
| IP rating | IP55 |
| Insulation class | Class F |
| Thermal overload | Inbuilt auto reset |
| Temperature rise | Class B |
| Frequency | 50Hz |
| Voltage | 230º-240º |
| Bearing type | Deep groove ball bearing with double contact lip seal |
| Bearing temperature rating | 150ºC |
MATERIAL
| Component | Material |
|---|---|
| Pump casing | 20% glass filled with ABS |
| Clacker | 20% glass filled with polycarbonate |
| Impeller | 20% glass filled with ABS |
| Baffle | 20% glass filled with ABS |
| Drain plug | 20% glass filled with ABS |
| Diffuser | 20% glass filled with ABS |
| Basket | Polypropylene |
| Shaft sleeve | Nylon |
| Motor shaft | 400 series stainless steel |
| End shield | Powder coated cast iron |
| Hair and lint pot O-ring | Low friction nitrile |
| Cord/Plug | Nitrile |
| Mechanical seal, 1/2″ type 6 (LTP1100 = type 6 3/4″ | |
| Flexible bellows | Nitrile |
| Stationary face | Ceramic |
| Rotating face | Carbon |
| Spring | 18-8 stainless steel |
